# GATE2016-3-24

Match the following part programming codes with their respective functions:

$\begin{array}{|l|l|l|l|} \hline & \textbf{Part Programming Codes} && \textbf{Functions} \\ \hline P. & \text{G01} & I. & \text{Spindle stop} \\ \hline Q. & \text{G03} & II. & \text{Spindle rotation, clockwise} \\ \hline R. & \text{M03} & III. & \text{Circular interpolation, anticlockwise} \\ \hline S. & \text{M05} & IV. & \text{Linear interpolation} \\ \hline \end{array}$

1. $P – II, Q – I, R – IV, S – III$
2. $P – IV, Q – II, R – III, S – I$
3. $P – IV, Q – III, R – II, S – I$
4. $P – III, Q – IV, R – II, S – I$

recategorized

## Related questions

A firm uses a turning center, a milling center and a grinding machine to produce two parts. The table below provides the machining time required for each part and the maximum machining time available on each machine. The profit per unit on parts $I$ and $II$ are $Rs. 40$ ... week (minutes) I II Turning machine $12$ $6$ $6000$ Milling center $4$ $10$ $4000$ Grinding Machine $2$ $3$ $1800$
The demand for a two-wheeler was $900$ units and $1030$ units in April $2015$ and May $2015$, respectively. The forecast for the month of April $2015$ was $850$ units. Considering a smoothing constant of $0.6$, the forecast for the month of June $2015$ is $850$ units $927$ units $965$ units $970$ units
In a single point turning operation with cemented carbide tool and steel work piece, it is found that the Taylor’s exponent is $0.25$. If the cutting speed is reduced by $50 \%$ then the tool life changes by ______ times.
For an orthogonal cutting operation, tool material is HSS, rake angle is $22^\circ$, chip thickness is $0.8 \: mm$, speed is $48 \: m/min$ and feed is $0.4 \: mm/rev$. The shear plane angle (in degrees) is $19.24$ $29.70$ $56.00$ $68.75$
Spot welding of two steel sheets each $2 \: mm$ thick is carried out successfully by passing $4 \: kA$ of current for $0.2$ seconds through the electrodes. The resulting weld nugget formed between the sheets is $5 \: mm$ in diameter. Assuming cylindrical shape for the nugget, the thickness of ...