Register

GATE2016-3-49

• recategorized by
270 views
0 0 votes

For an orthogonal cutting operation, tool material is HSS, rake angle is $22^\circ $, chip thickness is $0.8 \: mm$, speed is $48 \: m/min$ and feed is $0.4 \: mm/rev$. The shear plane angle (in degrees) is

  1. $19.24$
  2. $29.70$
  3. $56.00$
  4. $68.75$

Please log in or register to answer this question.

Related questions

0 0 votes
0 0 answers
329
329 views
Arjun asked Feb 24, 2017
329 views
GATE2016-3-51
In a single point turning operation with cemented carbide tool and steel work piece, it is found that the Taylor’s exponent is $0.25$. If the cutting speed is reduced by ...
0 0 votes
0 0 answers
269
269 views
Arjun asked Feb 24, 2017
269 views
GATE2016-3-55
A firm uses a turning center, a milling center and a grinding machine to produce two parts. The table below provides the machining time required for each part and the max...
0 0 votes
0 0 answers
336
336 views
Arjun asked Feb 24, 2017
336 views
GATE2016-3-54
The demand for a two-wheeler was $900$ units and $1030$ units in April $2015$ and May $2015$, respectively. The forecast for the month of April $2015$ was $850$ units. Co...
0 0 votes
0 0 answers
272
272 views
Arjun asked Feb 24, 2017
272 views
GATE2016-3-48
Spot welding of two steel sheets each $2 \: mm$ thick is carried out successfully by passing $4 \: kA$ of current for $0.2$ seconds through the electrodes. The resulting ...
Voting & Accepting an answer helps improve the community

Related questions

0 0 votes
0 0 answers
329
329 views
Arjun asked Feb 24, 2017
329 views
GATE2016-3-51
In a single point turning operation with cemented carbide tool and steel work piece, it is found that the Taylor’s exponent is $0.25$. If the cutting speed is reduced by ...
0 0 votes
0 0 answers
269
269 views
Arjun asked Feb 24, 2017
269 views
GATE2016-3-55
A firm uses a turning center, a milling center and a grinding machine to produce two parts. The table below provides the machining time required for each part and the max...
0 0 votes
0 0 answers
336
336 views
Arjun asked Feb 24, 2017
336 views
GATE2016-3-54
The demand for a two-wheeler was $900$ units and $1030$ units in April $2015$ and May $2015$, respectively. The forecast for the month of April $2015$ was $850$ units. Co...
0 0 votes
0 0 answers
272
272 views
Arjun asked Feb 24, 2017
272 views
GATE2016-3-48
Spot welding of two steel sheets each $2 \: mm$ thick is carried out successfully by passing $4 \: kA$ of current for $0.2$ seconds through the electrodes. The resulting ...
← Previous · GATE2016-3-48Next → · GATE2016-3-50
← Previous in category · GATE2016-3-48Next in category → · GATE2016-3-51
Position:
Show:
Answer:

Add Synced Question

×