search
Log In
0 votes

Which one of the following statements is TRUE for the ultrasonic machining (USM) process?

  1. In USM, the tool vibrates at subsonic frequency.
  2. USM does not employ magnetostrictive transducer.
  3. USM is an excellent process for machining ductile materials.
  4. USM often uses a slurry comprising abrasive-particles and water.
in Materials, Manufacturing and Industrial Engineering 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
In an orthogonal machining with a tool of $9^{\circ}$ orthogonal rake angle, the uncut chip thickness is $0.2$ mm. The chip thickness fluctuates between $0.25$ mm and $0.4$ mm. The ratio of the maximum shear angle to the minimum shear angle during machining is ___________.
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
0 votes
0 answers
A strip of $120$ mm width and $8$ mm thickness is rolled between two $300$ mm-diameter rolls to get a strip of $120$ mm width and $7.2$ mm thickness. The speed of the strip at the exit is $30$ m/min. There is no front or back tension. Assuming uniform ... $200$ MPa in the roll bite and $100\%$ mechanical efficiency, the minimum total power (in $kW$) required to drive the two rolls is _______.
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
A product made in two factories, $P$ and $Q$, is transported to two destinations, $R$ and $S$ ... optimized (the minimum) total transportation cost is $Y$ (in Rupees), then $(X-Y)$, in Rupees, is $0$ $15$ $35$ $105$
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
...