search
Log In
0 votes

The crystal structure of aluminium is.

  1. body-centered cubic.
  2. face-centered cubic.
  3. close-packed hexagonal.
  4. body-centered tetragonal.
in Applied Mechanics and Design 24.6k points
recategorized by

1 Answer

0 votes

Face Centered Cubic structure of aluminum (Taken from this website)

940 points 4 6 12
Answer:

Related questions

0 votes
0 answers
The rod $PQ$ of length $L=\sqrt{2}$ m, and uniformly distributed mass of $M=10$ kg, is released from rest at the position shown in the figure. The ends slide along the frictionless faces $OP$ and $OQ$. Assume acceleration due to gravity, $g=10 m/s^{2}$. The mass ... the figure is $(ML^{2}/12)$. At this instant, the magnitude of angular acceleration (in radian/$s^{2}$) of the rod is __________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A single-plate clutch has a friction disc with inner and outer radii of $20$ mm and $40$ mm, respectively. The friction lining in the disc is made in such a way that the coefficient of friction $\mu$ varies radially as $\mu=0.01r$, where $r$ is in mm. The clutch needs to transmit a friction torque of $18.85$ kN.mm. As per uniform pressure theory, the pressure (in MPa) on the disc is ________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Three masses are connected to a rotating shaft supported on bearings $A$ and $B$ as shown in the figure. The system is in a space where the gravitational effect is absent. Neglect the mass of shaft and rods connecting the masses. For $m_{1}= 10 kg, m_{2}=5 kg$ and ... $1000$ radian/s, the magnitude of the bearing reaction (in N) at location $B$ is ___________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A helical compression spring made of a wire of circular cross-section is subjected to a compressive load. The maximum shear stress induced in the cross-section of the wire is $24$MPa. For the same compressive load, if both the wire diameter and the mean coil diameter are doubled, the maximum shear stress (in MPa) induced in the cross-section of the wire is __________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A gear train shown in the figure consists of gears $P, Q, R,$ and $S$. Gear $Q$ and gear $R$ are mounted on the same shaft. All the gears are mounted on parallel shafts and the number of teeth of $P, Q, R$ and $S$ are $24, 45, 30,$ and $80$, respectively. Gear $P$ is rotating at $400$ rpm. The speed (in rpm) of the gear $S$ is __________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
...