search
Log In
0 votes
In an orthogonal machining with a tool of $9^{\circ}$ orthogonal rake angle, the uncut chip thickness is $0.2$ mm. The chip thickness fluctuates between $0.25$ mm and $0.4$ mm. The ratio of the maximum shear angle to the minimum shear angle during machining is ___________.
in Materials, Manufacturing and Industrial Engineering 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
During the turning of a $20$ mm- diameter steel bar at a spindle speed of $400$ rpm, a tool life of $20$ minute is obtained. When the same bar is turned at $200$ rpm, the tool life becomes $60$ minute. Assume that Taylor's tool life equation is valid. When the bar is turned at $300$ rpm, the tool life (in minute) is approximately. $25$ $32$ $40$ $50$
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
Two cutting tools with tool life equations given below are being compared: Tool $1$: $VT^{0.1}=150$ Tool $2$: $VT^{0.3}=300$ where $V$ is cutting speed in m/minute and $T$ is tool life in minutes. The breakeven cutting speed beyond which Tool $2$ will have a higher tool life is ________ m/minute.
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
0 votes
0 answers
A strip of $120$ mm width and $8$ mm thickness is rolled between two $300$ mm-diameter rolls to get a strip of $120$ mm width and $7.2$ mm thickness. The speed of the strip at the exit is $30$ m/min. There is no front or back tension. Assuming uniform ... $200$ MPa in the roll bite and $100\%$ mechanical efficiency, the minimum total power (in $kW$) required to drive the two rolls is _______.
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
...