Recent questions in Computer Integrated Manufacturing / GO Mechanical

1 answers

0 votes

GATE2019 ME-2: 54
In an orthogonal machining with a single point cutting tool of rake angle $10^{\circ}$, the uncut chip thickness and the chip thickness are $0.125$ mm and $0.22$ mm, respectively. Using Merchant’s first solution for the condition of minimum cutting force, the coefficient of friction at the chip-tool interface is _______ (round off to two decimal places).

In an orthogonal machining with a single point cutting tool of rake angle $10^{\circ}$, the uncut chip thickness and the chip thickness are $0.125$ mm and $0.22$ mm, resp...

Arjun

28.5k points

Arjun asked Feb 9, 2019

0 answers

0 votes

GATE2018-2-16
Metal removal in electric discharge machining takes place through ion displacement melting and vaporization corrosive and reaction plastic shear

Metal removal in electric discharge machining takes place throughion displacementmelting and vaporizationcorrosive and reactionplastic shear

Arjun

28.5k points

Arjun asked Feb 17, 2018

0 answers

0 votes

GATE2018-1-55
An electrochemical machining (ECM) is to be used to cut a through hole into a $12$ mm thick aluminum plate. The hole has a rectangular cross-section. $10 \: mm \times 30 \:mm$. The ECM operation will be accomplished in $2$ minutes, with efficiency of $90 \%$. Assuming ... , the current (in A) required is __________ (correct to two decimal places).

An electrochemical machining (ECM) is to be used to cut a through hole into a $12$ mm thick aluminum plate. The hole has a rectangular cross-section. $10 \: mm \times 30 ...

Arjun

28.5k points

Arjun asked Feb 17, 2018

0 answers

0 votes

GATE ME 2013 | Question: 15
A steel bar $200$ $mm$ in diameter is turned at a feed of $0.25$ $mm$/$rev$ with a depth of cut of $4$ $mm$. The rotational speed of the workpiece is $160$ $rpm$. The material removal rate in $mm^3$/$s$ is $160$ $167.6$ $1600$ $1675.5$

A steel bar $200$ $mm$ in diameter is turned at a feed of $0.25$ $mm$/$rev$ with a depth of cut of $4$ $mm$. The rotational speed of the workpiece is $160$ $rpm$. The mat...

piyag476

1.4k points

piyag476 asked Feb 19, 2017