Questions by gatecse

The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains corresponding to $\text{200 MPa}$, respectively, are$0.01$ and $0.01...

In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to the plane of the generatrix as shown in figure, the surface g...

The correct sequence of machining operations to be performed to finish a large diameter through hole isdrilling, boring, reamingboring, drilling, reamingdrilling, reaming...

In modern $\text{CNC}$ machine tools, the backlash has been eliminated bypreloaded ballscrewsrack and pinionratchet and pinionslider crank mechanism

Consider the surface roughness profile as shown in the figureThe center line average roughness ($R_{a}$, in $\mu m$) of the measured length $\text{(L)}$ is$0$$1$$2$$4$

In which of the following pairs of cycles, both cycles have at least one isothermal process?Diesel cycle and Otto cycleCarnot cycle and Stirling cycleBrayton cycle and Ra...

Superheated steam at $\text{1500 kPa}$, has a specific volume of $2.75$ $\text{m$^{3}$/kmol}$ and compressibility factor $\text{(Z)}$ of $0.95$. The temperature of steam ...

A hot steel spherical ball is suddenly dipped into a low temperature oil bath.Which of the following dimensionless parameters are required to determine instantaneous cent...

An infinitely long pin fin, attached to an isothermal hot surface, transfers heat at a steady rate $\dot{Q}_{1}$ to the ambient air. If the thermal conductivity of the fi...

​​​​​​​The relative humidity of ambient air at $\text{300 K}$ is $50\%$ with a partial pressure of water vapour equal to $p_{v}$. The saturation pressure of water at $\te...

Consider a reciprocating engine with crank radius $\text{R}$ and connecting rod of length $\text{L}$. The secondary unbalance force for this case is equivalent to primary...

A cantilever beam of length, $\text{L}$, and flexural rigidity, $\text{EI}$, is subjected to an end moment, $\text{M}$, as shown in the figure. The deflection of the beam...

A prismatic bar $\text{PQRST}$ is subjected to axial loads as shown in the figure. The segments having maximum and minimum axial stresses, respectively, are$\text{QR}$ an...

Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in the figure. This shear stress distribution representsdirect sh...

Robot $\text{Ltd}$. wishes to maintain enough safety stock during the lead time period between starting a new production run and its completion such that the probability ...

A pressure measurement device fitted on the surface of a submarine, located at a depth $\text{H}$ below the surface of an ocean, reads an absolute pressure of $\text{4.2 ...

Consider fully developed, steady state incompressible laminar flow of a viscous fluid between two large parallel horizontal plates. The bottom plate is fixed and the top ...

A rigid insulated tank is initially evacuated. It is connected through a valve to a supply line that carries air at a constant pressure and temperature of $\text{250 kPa}...

The figure shows an arrangement of a heavy propeller shaft in a ship. The combined polar mass moment of inertia of the propeller and the shaft is $\text{100 kg.m}^{2}$. T...

Consider a single degree of freedom system comprising a mass $\text{M}$, supported on a spring and a dashpot as shown in the figure.If the amplitude of the free vibration...