Questions without an upvoted answer in Applications

​​​In a psychrometric chart, one axis represents dry-bulb temperature. The axis, that is perpendicular to the dry-bulb temperature axis, representswet-bulb temperaturespe...

Consider a Pelton wheel of $1 \:m$ diameter. The magnitude of relative velocity of water at the bucket inlet is same as the magnitude of relative velocity of water at the...

In a vapour compression refrigeration cycle, the refrigerant enters the compressor in saturated vapour state at evaporator pressure, with specific enthalpy equal to $250$...

In a direct current arc welding process, the power source has an open circuit voltage of $100\: V$ and short circuit current of $1000 \:A$. Assume a linear relationship b...

In a steam power plant based on Rankine cycle, steam is initially expanded in a high-pressure turbine. The steam is then reheated in a reheater and finally expanded in a ...

An engine running on an air standard Otto cycle has a displacement volume $250\: cm^{3}$ and a clearance volume $35.7\: cm^{3}$. The pressure and temperature at the begin...

Consider an ideal vapour compression refrigeration cycle working on $\text{R-134a}$ refrigerant. The $\text{COP}$ of the cycle is $10$ and the refrigeration capacity is $...

A single jet Pelton wheel operates at $\text{300 rpm}$. The mean diameter of the wheel is $\text{2 m}$. Operating head and dimensions of jet are such that water comes out...

A circular disk of radius $r$ is confined to roll without slipping at $P$ and $Q$ as shown in the figure.If the plates have velocities as shown, the magnitude of angular ...

For an air-standard Diesel cycle,heat addition is at constant volume and heat rejection is at constant pressureheat addition is at constant pressure and heat rejection is...

The values of enthalpies at the stator inlet and rotor outlet of a hydraulic turbomachine stage are $h_1$ and $h_3$ respectively. The enthalpy at the stator outlet (or, r...

Consider a flow through a nozzle, as shown in the figure below.The air flow is steady, incompressible and inviscid. The density of air is $1.23 \: kg/m^3$. The pressure d...

Air is contained in a frictionless piston-cylinder arrangement as shown in the figure.The atmosphere pressure is $100$ kPa and the initial pressure of air in the cylinder...

Moist air at $105$ kPa, $30^\circ C$ and $80\%$ relative humidity flows over a cooling coil in an insulated air-conditioning duct. Saturated air exits the duct at $100$ k...

In a steam power plant, superheated steam at $10$ MPa and $500^\circ C$, is expanded isentropically in a turbine until it becomes a saturated vapour. It is then reheated ...

Keeping all other parameters identical, the Compression Ratio (CR) of an air standard diesel cycle is increased from $15$ to $21$. Take ratio of specific heats $=1.3$ and...

The compressor of a gas turbine plant, operating on an ideal intercooled Brayton cycle, accomplishes an overall compression ratio of $6$ in a two-stage compression proces...

For a Kaplan (axial flow) turbine, the outlet blade velocity diagram at a section is shown in the figure. The diameter at this section is $3\:m$.The hub and tip diam...

The figure shows a heat engine (HE) working between two reservoirs. The amount of heat $(Q_2)$ rejected by the heat engine is drawn by a heat pump (HP). The heat pump rec...

An air standard Otto cycle has thermal efficiency of $0.5$ and the mean effective pressure of the cycle is $1000 \: kPa$. For air, assume specific heat ratio $\gamma=1.4$...

As per common design practice, the three types of hydraulic turbines, in descending order of flow rate, areKaplan, Francis, PeltonPelton, Francis, KaplanFrancis, Kaplan, ...

Consider an ideal vapor compression refrigeration cycle. If the throttling process is replaced by an isentropic expansion process, keeping all the other processes unchang...

The rotor of a turbojet engine of an aircraft has a mass $180 \: kg$ and polar moment of inertia $10 \: kg \cdot m^2$ about the rotor axis. The rotor rotates at a constan...

A gas turbine with air as the working fluid has an isentropic efficiency of $0.70$ when operating at a pressure ratio of $3$. Now, the pressure ratio of the turbine is in...

A refrigerator operates between $120$ kPa and $800$ kPa in an ideal vapor compression cycle with $R-134a$ as the refrigerant. The refrigerant renters the compressor as sa...

A refrigerator operates between $120$ kPa and $800$ kPa in an ideal vapor compression cycle with $R-134a$ as the refrigerant. The refrigerant renters the compressor as sa...

A room contains $35$ kg of dry air and $0.5$ kg of water vapor. The total pressure and temperature of air in the room are $100$ kPa and $25^{\circ}$C respectively. Given ...

Steam enters an adiabatic turbine operating at steady state with an enthalpy of $3251.0 \: kJ/kg$ and leaves as a saturated mixture at $15 \:kPa$ with quality (dryness fr...

At the eye tip of a centrifugal impeller, blade velocity is $200 \: \text{m/s}$ while the uniform axial velocity at the inlet is $150 \: \text{m/s}$. If the sonic velocit...

A necessary precaution in selection of pumps for parallel operations is that$\text{H-Q}$ characteristics of both should be identicalBoth pumps should be centrifugal typeB...