search
Log In
0 votes

The welding process which uses a blanket of fusible granular flux is

  1. tungsten inert gas welding
  2. submerged arc welding
  3. electroslag welding
  4. thermit welding
in Materials, Manufacturing and Industrial Engineering 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
Under optimal conditions of the process the temperatures experienced by a copper work piece in fusion welding, brazing and soldering are such that $T_{\text{welding}} > T_{\text{soldering}}> T_{\text{brazing}}$ $T_{\text{soldering}} > T_{\text{welding}} > T_{\text{brazing}}$ ... $T_{\text{welding}} > T_{\text{brazing}} > T_{\text{soldering}}$
asked Feb 24, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
The Voltage-length characteristics of a direct current arc in an arc welding process is $V=(100+40l)$ ,where $l$ is the length of arc in $mm$ and $V$ is arc voltages in volts.during a welding process,the arc length varies between $1$ and $2 \: mm$ and welding current is in range $200-250 \: A$.Assuming a linear power source,the short circuit current is_____$A$
asked Feb 24, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
Gray cast iron blocks of size $100mm\times 50mm\times 10mm$ with a central spherical cavity of diameter $4 \:mm$ are sand cast.The shrinkage allowance for the pattern is $3\%$.The ratio of the volume of the pattern to the volume of casting is
asked Feb 24, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
A gas tungsten arc welding operation is performed using a current of $250 \: A$ and an arc voltage of $20 \: V$ at a welding speed of $5 \: mm/s$. Assuming that the arc efficiency is $70 \%$, the net heat input per unit length of the weld will be _________$kJ/mm$ (round off to one decimal place)
asked Feb 9, 2019 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
During a TIG welding process, the arc current and arc voltage were $50$ $A$ and $60$ $V$, respectively, when the welding speed was $150$ $mm/min$. In another process, the TIG welding is carried out at a welding speed of $120$ $mm/min$ at the same arc voltage and heat input ... so that weld quality remains the same. The welding current (in $A$) for this process is $40.00$ $44.72$ $55.90$ $62.25$
asked Feb 24, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
...