search
Log In
0 votes
A rod is subjected to a uni-axial load within linear elastic limit. When the change in the stress is $200$ $MPa$, the change in the strain is $0.001$. If the Poisson’s ratio of the rod is $0.3$, the modulus of rigidity (in $GPa$) is ________________
in Mechanics of Materials 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A hollow shaft of $1 \: m$ length is designed to transmit a power of $30\: kW$ at $700 \text{rpm}$. The maximum permissible angle of twist in the shaft is $1^{\circ}$. The inner diameter of the shaft is $0.7$ times the outer diameter. The modulus of rigidity is $80 \: GPa$. The outside diameter (in $mm$) of the shaft is__________
asked Feb 24, 2017 in Mechanics of Materials Arjun 24.6k points
0 votes
0 answers
A cantilever beam with square cross-section of $6 \: mm$ side is subjected to a load of $2 \: kN$ normal to the top surface as shown in the figure. The Young’s modulus of elasticity of the material of the beam is $210 \: GPa$. The magnitude of slope (in radian) at $Q$ ($20 \: mm$ from the fixed end) is ________
asked Feb 24, 2017 in Mechanics of Materials Arjun 24.6k points
0 votes
0 answers
A rope-brake dynamometer attached to the crank shaft of an $I.C$. engine measures a brake power of $10$ $kW$ when the speed of rotation of the shaft is $400$ $rad/s$. The shaft torque (in $N$-$m$) sensed by the dynamometer is ___________
asked Feb 24, 2017 in Mechanics of Materials Arjun 24.6k points
0 votes
0 answers
The uniaxial yield stress of a material is $300$ $MPa$. According to von Mises criterion, the shear yield stress (in $MPa$) of the material is _______
asked Feb 24, 2017 in Mechanics of Materials Arjun 24.6k points
0 votes
0 answers
A metallic rod of $500$ $mm$ length and $50$ $mm$ diameter, when subjected to a tensile force of $100$ $kN$ at the ends, experiences a n increase in its length by $0.5$ $mm$ and a reduction in its diameter by $0.015$ $mm$. The Poisson’s ratio of the rod material is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
...