# GATE2015-2-33

A cantilever beam with square cross-section of $6 \: mm$ side is subjected to a load of $2 \: kN$ normal to the top surface as shown in the figure. The Young’s modulus of elasticity of the material of the beam is $210 \: GPa$. The magnitude of slope (in radian) at $Q$ ($20 \: mm$ from the fixed end) is ________

recategorized

## Related questions

A cantilever beam OP is connected to another beam PQ with a pin joint as shown in the figure. A load of $10$ $kN$ is applied at the mid-point of PQ. The magnitude of bending moment (in $kN$-$m$) at fixed end O is $2.5$ $5$ $10$ $25$
A hollow shaft of $1 \: m$ length is designed to transmit a power of $30\: kW$ at $700 \text{rpm}$. The maximum permissible angle of twist in the shaft is $1^{\circ}$. The inner diameter of the shaft is $0.7$ times the outer diameter. The modulus of rigidity is $80 \: GPa$. The outside diameter (in $mm$) of the shaft is__________
A rope-brake dynamometer attached to the crank shaft of an $I.C$. engine measures a brake power of $10$ $kW$ when the speed of rotation of the shaft is $400$ $rad/s$. The shaft torque (in $N$-$m$) sensed by the dynamometer is ___________
The uniaxial yield stress of a material is $300$ $MPa$. According to von Mises criterion, the shear yield stress (in $MPa$) of the material is _______
A rod is subjected to a uni-axial load within linear elastic limit. When the change in the stress is $200$ $MPa$, the change in the strain is $0.001$. If the Poisson’s ratio of the rod is $0.3$, the modulus of rigidity (in $GPa$) is ________________