Register

GATE Mechanical 2021 Set 2 | Question: 9

• edited by
0 votes
0 votes

The allowance provided in between a hole and a shaft is calculated from the difference between

  1. lower limit of the shaft and the upper limit of the hole
  2. upper limit of the shaft and the upper limit of the hole
  3. upper limit of the shaft and the lower limit of the hole
  4. lower limit of the shaft and the lower limit of the hole
• edited by

Please log in or register to answer this question.

← PreviousNext →
← Previous in categoryNext in category →
Answer:

Related questions

2 answers
2 votes
go_editor asked Mar 1, 2021
GATE Mechanical 2021 Set 2 | GA Question: 9
Consider a square sheet of side $1$ unit. The sheet is first folded along the main diagonal. This is followed by a fold along its line of symmetry. The resulting folded shape is again folded along its line of symmetry. The area of each face of the final folded shape, ... units, equal to _________ $\frac{1}{4}$ $\frac{1}{8}$ $\frac{1}{16}$ $\frac{1}{32}$
Consider a square sheet of side $1$ unit. The sheet is first folded along the main diagonal. This is followed by a fold along its line of symmetry. The resulting folded s...
0 answers
0 votes
go_editor asked Mar 1, 2021
GATE Mechanical 2021 Set 2 | Question: 4
The Cast Iron which possesses all the carbon in the combined form as cementite is known as Grey Cast Iron Spheroidal Cast Iron Malleable Cast Iron White Cast Iron
The Cast Iron which possesses all the carbon in the combined form as cementite is known asGrey Cast IronSpheroidal Cast IronMalleable Cast IronWhite Cast Iron
0 answers
0 votes
go_editor asked Mar 1, 2021
GATE Mechanical 2021 Set 2 | Question: 5
The size distribution of the powder particles used in Powder Metallurgy process can be determined by Laser scattering Laser reflection Laser absorption Laser penetration
The size distribution of the powder particles used in Powder Metallurgy process can be determined byLaser scatteringLaser reflectionLaser absorptionLaser penetration
0 answers
0 votes
go_editor asked Mar 1, 2021
GATE Mechanical 2021 Set 2 | Question: 7
The machining process that involves ablation is Abrasive Jet Machining Chemical Machining Electrochemical Machining Laser Beam Machining
The machining process that involves ablation isAbrasive Jet MachiningChemical MachiningElectrochemical MachiningLaser Beam Machining
Voting & Accepting an answer helps improve the community
Link Copied!