Register

GATE2020-ME-2: 23

• retagged by
0 votes
0 votes

Consider the following network of activities, with each activity named $\textbf{A – L}$, illustrated in the nodes of the network.

The number of hours required for each activity is shown alongside the nodes. The slack on the activity $\textbf{L}$, is _______ hours.

• retagged by

Please log in or register to answer this question.

← PreviousNext →
← Previous in categoryNext in category →
Answer:

Related questions

0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 20
A beam of negligible mass is hinged at support $P$ and has a roller support $Q$ as shown in the figure. A point load of $1200 \: N$ is applied at point $R$. The magnitude of the reaction force at support $Q$ is _________ $N$.
A beam of negligible mass is hinged at support $P$ and has a roller support $Q$ as shown in the figure.A point load of $1200 \: N$ is applied at point $R$. The magnitude ...
0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 21
A machine member is subjected to fluctuating stress $\sigma = \sigma_0 \cos (8 \pi t)$. The endurance limit of the material is $350$ MPa. If the factor of safety used in the design is $3.5$ then the maximum allowable value of $\sigma_0$ is _______ MPa. (round off to $2$ decimal places)
A machine member is subjected to fluctuating stress $\sigma = \sigma_0 \cos (8 \pi t)$. The endurance limit of the material is $350$ MPa. If the factor of safety used in ...
0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 22
A bolt head has to be made at the end of a rod of diameter $d=12$ mm by localized forging (upsetting) operation. The length of the unsupported portion of the rod is $40$ mm. To avoid buckling of the rod, a closed forging operation has to be performed with a maximum die diameter of _______ mm.
A bolt head has to be made at the end of a rod of diameter $d=12$ mm by localized forging (upsetting) operation. The length of the unsupported portion of the rod is $40$ ...
0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 25
If a reversed Carnot cycle operates between the temperature limits of $27^\circ C$ and $-3^\circ C$, then the ratio of the COP of a refrigerator to that of a heat pump (COP of refrigerator / COP of heat pump) based on the cycle is __________ (round off to $2$ decimal places).
If a reversed Carnot cycle operates between the temperature limits of $27^\circ C$ and $-3^\circ C$, then the ratio of the COP of a refrigerator to that of a heat pump (C...
Voting & Accepting an answer helps improve the community
Link Copied!