search
Log In
0 votes

The non-traditional machining process that essentially requires vacuum is

  1. electron beam machining
  2. electro chemical machining
  3. electro chemical discharge machining
  4. electro discharge machining
in Materials, Manufacturing and Industrial Engineering 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
The tool life equation for HSS tool is $VT^{0.14}f^{0.7}d^{0.4}$ = constant. The tool life $(T)$ of $30 \: min$ is obtained using the following cutting conditions: $V=45\:m/min$, $f=0.35 \: mm$, $d=2.0 \: mm$ If speed $(V)$, feed $(f)$ and depth of cut $(d)$ are increased individually by $25\%$, the tool life (in $min$) is $0.15$ $1.06$ $22.50$ $30.0$
asked Feb 24, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
0 votes
0 answers
The main cutting force acting on a tool during the turning (orthogonal cutting) operation of a metal is $400$ $N$. The turning was performed using $2$ $mm$ depth of cut and $0.1$ $mm/rev$ feed rate. The specific cutting pressure (in $N$/$mm^2$) is $1000$ $2000$ $3000$ $4000$
asked Feb 19, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
Better surface finish is obtained with a large rake angle because the area of shear plane decreases resulting in the decrease in shear force and cutting force the tool becomes thinner and the cutting force is reduced less heat is accumulated in the cutting zone the friction between the chip and the tool is less
asked Feb 19, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
...