search
Log In
0 votes

In orthogonal turning of a bar of $100$ $mm$ diameter with a feed of $0.25$ $mm$/$rev$, depth of cut of $4$ $mm$ and cutting velocity of $90$ $m$/$min$, it is observed that the main (tangential) cutting force is perpendicular to the friction force acting at the chip-tool interface. The main (tangential) cutting force is $1500$ $N$.

The normal force acting at the chip-tool interface in $N$ is

  1. $1000$
  2. $1500$
  3. $2000$
  4. $2500$

 

in Materials, Manufacturing and Industrial Engineering 1.4k points 4 7 17
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
In orthogonal turning of a bar of $100$ $mm$ diameter with a feed of $0.25$ $mm$/$rev$, depth of cut of $4$ $mm$ and cutting velocity of $90$ $m$/$min$, it is observed that the main (tangential) cutting force is perpendicular to the friction force acting at the chip ... main (tangential) cutting force is $1500$ $N$. The orthogonal rake angle of the cutting tool in degree is zero $3.58$ $5$ $7.16$
asked Feb 19, 2017 in Materials, Manufacturing and Industrial Engineering piyag476 1.4k points
0 votes
0 answers
Cutting tool is much harder than the workpiece. Yet the tool wears out during the tool-work interaction, because extra hardness is imparted to the workpiece due to coolant used oxide layers on the workpiece surface impart extra hardness to it extra hardness is imparted to the workpiece due to severe rate of strain vibration is induced in the machine tool
asked Feb 19, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
A through hole is drilled in an aluminium alloy plate of $15 \: mm$ thickness with a drill bit of diameter $10$ mm, at a feed of $0.25$ mm/rev and a spindle speed of $1200$ rpm. If the specific energy required for cutting this material is $0.7 \: N \cdot m/mm^3$, the power required for drilling is ____________$W$ (round off to two decimal places)
asked Feb 9, 2019 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
Taylor’s tool life equation is given by $VT^n=C$, where $V$ is in $m/min$ and $T$ is in $min$. In a turning operation, two tools $X$ and $Y$ are used. For tool $X$, $n=0.3$ and $C=60$ and for tool $Y$, $n=0.6$ and $C=90$. Both the tools will have the same tool life for the cutting speed (in $m/min$, round off to one decimal place) of ____________
asked Feb 9, 2019 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
0 votes
0 answers
A block of length $200$ mm is machined by a slab milling cutter $34$ mm in diameter. The depth of cut and table feed are set at $2$ mm and $18$ mm/minute, respectively. Considering the approach and the over travel of the cutter to be same, the minimum estimated machining time per pass is ________ minutes.
asked Feb 27, 2017 in Materials, Manufacturing and Industrial Engineering Arjun 24.6k points
...