search
Log In
0 votes

Engineering strain of a mild steel sample is recorded as $0.100\%$. The true strain is

  1. $0.010\%$
  2. $0.055\%$
  3. $0.099\%$
  4. $0.101\%$
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
In a sheet metal of $2$ $mm$ thickness a hole of $10$ $mm$ diameter needs to be punched. The yield strength in tension of the sheet material is $100$ $MPa$ and its ultimate shear strength is $80$ $MPa$. The force required to punch the hole (in $kN$) is __________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A square plate of dimension $L \times L$ is subjected to a uniform pressure load $p=250 \: MPa$ on its edges as shown in the figure. Assume plane stress conditions. The Young’s modulus $E=200 \: GPa$ .The deformed shape is a square of dimension $L− 2\delta$. If $L = 2 \: m$ and $\delta=0.001 \: m$, the Poisson’s ratio of the plate material is __________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Two masses m are attached to opposite sides of a rigid rotating shaft in the vertical plane. Another pair of equal masses $m_1$ is attached to the opposite sides of the shaft in the vertical plane as shown in figure. Consider $m=1 \: kg$, $e=50 \: mm$, $e_1=20 \: mm$, $b=0.3 \: m$, $a=2 \: m$ and $a_1 = 2.5 \: m$. For the system to be dynamically balanced, $m_1$ should be ________ $kg$.
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A beam of length $L$ is carrying a uniformly distributed load w per unit length. The flexural rigidity of the beam is $EI$. The reaction at the simple support at the right end is $\dfrac{wL}{2} \\$ $\dfrac{3wL}{8} \\$ $\dfrac{wL}{4} \\$ $\dfrac{wL}{8}$
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Two circular shafts made of same material, one solid (S) and one hollow (H), have the same length and polar moment of inertia. Both are subjected to same torque. Here, $\theta _S$ is the twist and $\tau _S$ is the maximum shear stress in the solid shaft, whereas $\theta _H$ is the twist ... $\tau _S>\tau _H$ $\theta _S<\theta _H$ and $\tau _S<\tau _H$ $\theta _S=\theta _H$ and $\tau _S<\tau _H$
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
...