search
Log In
0 votes

The number of degrees of freedom of the planetary gear train shown in the figure is

  1. $0$
  2. $1$
  3. $2$
  4. $3$
in Theory of Machines 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A helical gear with $20^{\circ}$ pressure angle and $30^{\circ}$ helix angle mounted at the mid-span of a shaft that is supported between two bearings at the ends. The nature of the stresses induced in the shaft is normal stress due to bending only ... bending in two planes and axial loading; shear stress due to torsion normal stress due to bending in two planes; shear stress due to torsion
asked Feb 19, 2020 in Applied Mechanics and Design jothee 4.9k points
0 votes
0 answers
A gear train is made up of five spur gears as shown in the figure. Gear $2$ is driver and gear $6$ is driven member. $N_2$, $N_3$, $N_4$, $N_5$ and $N_6$ represent number of teeth on gears $2$, $3$, $4$, $5$, and $6$ respectively. The gear(s) which act(s) as idler(s) is/are Only $3$ Only $4$ Only $5$ Both $3$ and $5$
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A pinion with radius $r_1$, and inertia $I_1$ is driving a gear with radius $r_2$ and inertia $I_2$. Torque $\tau _1$ is applied on pinion. The following are free body diagrams of pinion and gear showing important forces ($F_1$ and $F_2$) of interaction. Which of the following relations ... $F_2=I_2\dfrac{1}{r_2}\ddot{\theta _1};$
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A gear train shown in the figure consists of gears $P, Q, R,$ and $S$. Gear $Q$ and gear $R$ are mounted on the same shaft. All the gears are mounted on parallel shafts and the number of teeth of $P, Q, R$ and $S$ are $24, 45, 30,$ and $80$, respectively. Gear $P$ is rotating at $400$ rpm. The speed (in rpm) of the gear $S$ is __________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A spur pinion of pitch diameter $50$ $mm$ rotates at $200$ $rad/s$ and transmits $3 kW$ power. The pressure angle of the tooth of the pinion is $20^\circ$. Assuming that only one pair of the teeth is in contact, the total force (in newton) exerted by a tooth of the pinion on the tooth on a mating gear is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
...