Register

GATE2019 ME-2: 16

• recategorized by
413 views
0 0 votes

The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative motion between the tool and the workpiece) to produce a roughened surface with a regular pattern is

  1. Roll forming
  2. Strip forming
  3. Knurling
  4. Chamfering

Please log in or register to answer this question.

Related questions

0 0 votes
0 0 answers
452
452 views
Arjun asked Feb 9, 2019
452 views
GATE2019 ME-2: 15
The fluidity of molten metal of cast alloys (without any addition of fluxes) increases with increase inviscositysurface tensionfreezing rangedegree of superheat
0 0 votes
0 0 answers
486
486 views
Arjun asked Feb 9, 2019
486 views
GATE2019 ME-2: 50
The figure shows a pouring arrangement for casting of a metal block. Frictional losses are negligible. The acceleration due to gravity is $9.81 \: m/s^2$ .The time (in $s...
0 0 votes
0 0 answers
368
368 views
Arjun asked Feb 9, 2019
368 views
GATE2019 ME-2: 51
A gas tungsten arc welding operation is performed using a current of $250 \: A$ and an arc voltage of $20 \: V$ at a welding speed of $5 \: mm/s$. Assuming that the arc e...
0 0 votes
0 0 answers
394
394 views
Arjun asked Feb 9, 2019
394 views
GATE2019 ME-2: 52
The thickness of a sheet is reduced by rolling (without any change in width) using $600 \: mm$ diameter rolls. Neglect elastic deflection of the rolls and assume that the...
Voting & Accepting an answer helps improve the community

Related questions

0 0 votes
0 0 answers
452
452 views
Arjun asked Feb 9, 2019
452 views
GATE2019 ME-2: 15
The fluidity of molten metal of cast alloys (without any addition of fluxes) increases with increase inviscositysurface tensionfreezing rangedegree of superheat
0 0 votes
0 0 answers
486
486 views
Arjun asked Feb 9, 2019
486 views
GATE2019 ME-2: 50
The figure shows a pouring arrangement for casting of a metal block. Frictional losses are negligible. The acceleration due to gravity is $9.81 \: m/s^2$ .The time (in $s...
0 0 votes
0 0 answers
368
368 views
Arjun asked Feb 9, 2019
368 views
GATE2019 ME-2: 51
A gas tungsten arc welding operation is performed using a current of $250 \: A$ and an arc voltage of $20 \: V$ at a welding speed of $5 \: mm/s$. Assuming that the arc e...
0 0 votes
0 0 answers
394
394 views
Arjun asked Feb 9, 2019
394 views
GATE2019 ME-2: 52
The thickness of a sheet is reduced by rolling (without any change in width) using $600 \: mm$ diameter rolls. Neglect elastic deflection of the rolls and assume that the...
← Previous · GATE2019 ME-2: 17Next → · GATE2019 ME-2: 15
← Previous in category · GATE2019 ME-2: 17Next in category → · GATE2019 ME-2: 15
Position:
Show:
Answer:

Add Synced Question

×