search
Log In
0 votes
A pair of spur gears with module $5$ $mm$ and a center distance of $450$ $mm$ is used for a speed reduction of $5:1$. The number of teeth on pinion is _______
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
For the given statements: Mating spur gear teeth is an example of higher pair A revolute joint is an example of lower pair Indicate the correct answer. Both $I$ and $II$ are false $I$ is true and $II$ is false $I$ is false and $II$ is true Both $I$ and $II$ are true
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A gear train shown in the figure consists of gears $P, Q, R,$ and $S$. Gear $Q$ and gear $R$ are mounted on the same shaft. All the gears are mounted on parallel shafts and the number of teeth of $P, Q, R$ and $S$ are $24, 45, 30,$ and $80$, respectively. Gear $P$ is rotating at $400$ rpm. The speed (in rpm) of the gear $S$ is __________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A spur pinion of pitch diameter $50$ $mm$ rotates at $200$ $rad/s$ and transmits $3 kW$ power. The pressure angle of the tooth of the pinion is $20^\circ$. Assuming that only one pair of the teeth is in contact, the total force (in newton) exerted by a tooth of the pinion on the tooth on a mating gear is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
In an epicyclic gear train, shown in the figure, the outer ring gear is fixed, while the sun gear rotates counterclockwise at $100$ rpm. Let the number of teeth on the sun, planet and outer gears to be $50, 25$ and $100$, respectively. The ratio of magnitudes of angular velocity of the planet gear to the angular velocity of the carrier arm is ________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A compound gear train with gears $P$, $Q$, $R$ and $S$ has number of teeth $20$, $40$, $15$ and $20$, respectively. Gears $Q$ and $R$ are mounted on the same shaft as shown in the figure below. The diameter of the gear $Q$ is twice that of the gear $R$. If the module of the gear $R$ is $2$ $mm$, the center distance in $mm$ between gears $P$ and $S$ is $40$ $80$ $120$ $160$
asked Feb 19, 2017 in Applied Mechanics and Design piyag476 1.4k points
...