search
Log In
0 votes

Consider a beam with circular cross-section of diameter $d$. The ratio of the second moment of area about the neutral axis to the section modulus of the area is

  1. $\dfrac{d}{2} \\$
  2. $\dfrac{\pi d}{2} \\$
  3. $d \\$
  4. $\pi d$
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A horizontal bar, fixed at one end $(x=0)$, has a length of $1$ m, and cross-sectional area of $100 mm^{2}$. Its elastic modulus varies along its length as given by $E(x)=100 e^{-x}$ GPa, where $x$ is the length coordinate (in m) along the axis of the bar. An axial tensile load of $10$ kN is applied at the free end $(x=1)$. The axial displacement of the free end is _________ mm
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A rectangular region in a solid is in a state of plane strain. The $(x, y)$ coordinates of the corners of the undeformed rectangle are given by $P(0, 0), Q(4, 0), R(4, 3), S(0, 3)$. The rectangle is subjected to uniform strains, $\varepsilon _{xx}=0.001, \varepsilon _{yy}=0.002,\gamma _{xy}=0.003$. The deformed length of the elongated diagonal, up to three decimal places is _______ units.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A point mass of $100$ kg is dropped onto a massless elastic bar (cross-sectional area $= 100 mm^{2}$, length $= 1$ m, Young's modulus$=100$ GPa) from a height $H$ of $10$ mm as shown (Figure is not to scale). If $g= 10 m/s^{2}$, the maximum compression of the elastic bar is _______ mm
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
1 answer
In the engineering stress-strain curve for mild steel, the Ultimate Tensile Strength (UTS) refers to Yield stress Proportional limit Maximum stress Fracture stress
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
In a metal forming operation when the material has just started yielding. the principal stresses are $\sigma_{1}=+180 MPa, \sigma_{2}=-100 MPa, \sigma_{3}=0$. Following von Mises' criterion, the yield stress is _________ MPa.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
...