search
Log In
0 votes
A single degree of freedom system has a mass of $2$ $kg$, stiffness $8$ $N/m$ and viscous damping ratio $0.02$. The dynamic magnification factor at an excitation frequency of $1.5$ $rad/s$ is _______
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A butt weld joint is developed on steel plates having yield and ultimate tensile strength of $500$ $MPa$ and $700$ $MPa$, respectively. The thickness of the plates is $8$ $mm$ and width is $20$ $mm$. Improper selection of welding parameters caused an undercut of $3$ $mm$ depth along the weld. The maximum transverse tensile load (in $kN$) carrying capacity of the developed weld joint is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A bolt of major diameter $12$ $mm$ is required to clamp two steel plates. Cross sectional area of the threaded portion of the bolt is $84.3$ $mm^2$. The length of the threaded portion in grip is $30$ $mm$, while the length of the unthreaded portion in grip is $8$ $mm$. Young's modulus of material is $200$ $GPa$. The effective stiffness (in $MN/m$) of the bolt in the clamped zone is_______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A thin gas cylinder with an internal radius of $100$ $mm$ is subject to an internal pressure of $10$ $MPa$. The maximum permissible working stress is restricted to $100$ $MPa$. The minimum cylinder wall thickness (in $mm$) for safe design must be _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A shaft is subjected to pure torsional moment. The maximum shear stress developed in the shaft is $100$ $MPa$. The yield and ultimate strengths of the shaft material in tension are $300$ $MPa$ and $450$ $MPa$, respectively. The factor of safety using maximum distortion energy (von-Mises) theory is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Ball bearings are rated by a manufacturer for a life of $10^6$ revolutions. The catalogue rating of a particular bearing is $16$ $kN$. If the design load is $2$ $kN$, the life of the bearing will be $p\times 10^6$ revolutions, where $p$ is equal to _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
...