search
Log In
Welcome to GO Mechanical, where you can ask questions and receive answers from other members of the community.

0 votes
Water enters a circular pipe of length $L=5.0$ m and diameter $D=0.20$m with Reynolds number $Re_D=500$. The velocity profile at the inlet of the pipe is uniform while it is parabolic at the exit. The Reynolds number at the exit of the pipe is _________
in Others 21.2k points 4 126 349
retagged by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
Water flows through two different pipes $A$ and $B$ of the same circular cross-section but at different flow rates. The length of pipe $A$ is $1.0 \: m$ and that of pipe $B$ is $2.0 \: m$. The flow in both the pipes is laminar and fully developed ... head loss across the length of the pipes is same, the ratio of volume flow rates $Q_B/Q_A$ is __________ (round off to two decimal places).
asked Feb 9, 2019 in Others Arjun 21.2k points
0 votes
0 answers
Water flowing at the rate of $1$ kg/s through a system is heated using an electric heater such that the specific enthalpy of the water increases by $2.50 \: kJ/kg$ and the specific entropy increases by $0.007 \: kJ/kg \cdot K$. The power input to the ... . Assuming an ambient temperature of $300 \: K$, the irreversibility rate of the system is __________ $kW$ (round off to two decimal places).
asked Feb 9, 2019 in Others Arjun 21.2k points
0 votes
0 answers
Water flows through a pipe with a velocity given by $\overrightarrow{V}= \bigg( \dfrac{4}{t}+x+y \bigg) \hat{j} \: m/s$, where $\hat{j}$ is the unit vector in the $y$ direction, $t(>0)$ is in seconds, and $x$ and $y$ are in meters. The magnitude of total acceleration at the point $(x,y)=(1,1)$ at $t=2\: s$ is ______$m/s^2$
asked Feb 9, 2019 in Others Arjun 21.2k points
0 votes
0 answers
An idealized centrifugal pump (blade outer radius of $50 \: mm$) consumes $2 \: kW$ power while running at $3000 \: rpm$. The entry of the liquid into the pump is axial and exit from the pump is radial with respect to impeller. If the losses are neglected, then the mass flow rate of the liquid through the pump is ___________ $kg/s$ (round off to two decimal places)
asked Feb 9, 2019 in Others Arjun 21.2k points
0 votes
0 answers
A $60$ mm-diameter water jet strikes a plate containing a hole of $40$ mm diameter as shown in the figure. Part of the jet passes through the hole horizontally and the remaining is deflected vertically. The density of water is $1000 kg/m^{3}$. If velocities are as indicated in the figure, the magnitude of horizontal force (in N) required to hold the plate is _________.
asked Feb 27, 2017 in Others Arjun 21.2k points
...