Register

GATE2016-3-22

• recategorized by
0 votes
0 votes

In a wire-cut EDM process the necessary conditions that have to be met for making a successful cut are that

  1. wire and sample are electrically non-conducting
  2. wire and sample are electrically conducting
  3. wire is electrically conducting and sample is electrically non-conducting
  4. sample is electrically conducting and wire is electrically non-conducting
• recategorized by
User Avatar

Please log in or register to answer this question.

← PreviousNext →
← Previous in categoryNext in category →
Answer:

Related questions

0 answers
0 votes
Arjun asked Feb 24, 2017
GATE2016-3-23
Internal gears are manufactured byhobbingshaping with pinion cuttershaping with rack cuttermilling
0 answers
0 votes
Arjun asked Feb 24, 2017
GATE2016-3-55
A firm uses a turning center, a milling center and a grinding machine to produce two parts. The table below provides the machining time required for each part and ... machine$12$6$6000$Milling center$4$10$4000$Grinding Machine$2$3$1800$
0 answers
0 votes
Arjun asked Feb 24, 2017
GATE2016-3-54
The demand for a two-wheeler was $900$ units and $1030$ units in April $2015$ and May $2015$, respectively. The forecast for the month of April $2015$ was $850$ ... for the month of June $2015$ is$850$ units$927$ units$965$ units$970$ units
0 answers
0 votes
Arjun asked Feb 24, 2017
GATE2016-3-51
In a single point turning operation with cemented carbide tool and steel work piece, it is found that the Taylor’s exponent is $0.25$. If the cutting speed is reduced by $50 \%$ then the tool life changes by ______ times.
0 answers
0 votes
Arjun asked Feb 24, 2017
GATE2016-3-49
For an orthogonal cutting operation, tool material is HSS, rake angle is $22^\circ $, chip thickness is $0.8 \: mm$, speed is $48 \: m/min$ and feed is $0.4 \: mm/rev$. The shear plane angle (in degrees) is$19.24$29.70$56.00$68.75$
Voting & Accepting an answer helps improve the community
Link Copied!