search
Log In
0 votes
For an inline slider-crank mechanism, the lengths of the crank and connecting rod are $3$ m and $4$ m, respectively. At the instant when the connecting rod is perpendicular to the crank, if the velocity of the slider is $1$ m/s, the magnitude of angular velocity (upto $3$ decimal points accuracy) of the crank is ________ radian/s
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A thin uniform rigid bar of Length $L$ and mass $M$ is hinged at point $O$, located at a distance of $\dfrac{L}{3}$ from one of its ends. The bar is further supported using springs, each of stiffness $k$, located at the two ends. A particle of mass $m=\dfrac{M}{4}$ is fixed at one end of ... is $\sqrt{\dfrac{5k}{M}} \\$ $\sqrt{\dfrac{5k}{2M}} \\$ $\sqrt{\dfrac{3k}{2M}} \\$ $\sqrt{\dfrac{3k}{M}}$
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Consider the schematic of a riveted lap joint subjected to tensile load $F$, as shown below. Let $d$ be the diameter of the rivets, and $S_{f}$ be the maximum permissible tensile stress in the plates. What should be the minimum value for the thickness of the plates to guard against tensile failure of the plates? ... $\dfrac{F}{S_{f}W} \\$ $\dfrac{F}{S_{f}(W-d)} \\$ $\dfrac{2F}{S_{f}W}$
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
The damping ratio for a viscously damped spring-mass system, governed by the relationship $m \dfrac{d^{2}x}{dt^{2}}+c\dfrac{dx}{dt}+kx=F(t)$, is given by $\sqrt{\dfrac{c}{mk}} \\$ $\dfrac{c}{2\sqrt{km}} \\$ $\dfrac{c}{\sqrt{km}} \\$ $\sqrt{\dfrac{c}{2mk}}$
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A $10$ mm deep cylindrical cup with diameter of $15$ mm is drawn from a circular blank. Neglecting the variation in the sheet thickness, the diameter (upto $2$ decimal points accuracy) of the blank is _________ mm.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
In an epicyclic gear train, shown in the figure, the outer ring gear is fixed, while the sun gear rotates counterclockwise at $100$ rpm. Let the number of teeth on the sun, planet and outer gears to be $50, 25$ and $100$, respectively. The ratio of magnitudes of angular velocity of the planet gear to the angular velocity of the carrier arm is ________.
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
...