search
Log In
0 votes

A bolted joint has four bolts arranged as shown in figure. The cross sectional area of each bolt is $25$ $mm^2$. A torque $T$ = $200N-m$ is acting on the joint. Neglecting friction due to clamping force, maximum shear stress in a bolt is ______ $MPa$.

in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A single degree of freedom spring-mass system is subjected to a harmonic force of constant amplitude. For an excitation frequency of $\sqrt{\dfrac{3k}{m}}$, the ratio of the amplitude of steady state response to the static deflection of the spring is __________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
The static deflection of a spring under gravity, when a mass of $1 \:kg$ is suspended from it, is $1 \: mm$. Assume the acceleration due to gravity $g =10 \: m/s^2$. The natural frequency of this spring-mass system (in $rad/s$) is_____________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A bolt of major diameter $12$ $mm$ is required to clamp two steel plates. Cross sectional area of the threaded portion of the bolt is $84.3$ $mm^2$. The length of the threaded portion in grip is $30$ $mm$, while the length of the unthreaded portion in grip is $8$ $mm$. Young's modulus of material is $200$ $GPa$. The effective stiffness (in $MN/m$) of the bolt in the clamped zone is_______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Which of the bearings given below SHOULD NOT be subjected to a thrust load? Deep groove ball bearing Angular contact ball bearing Cylindrical (straight) roller bearing Single row tapered roller bearing
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A steel plate, connected to a fixed channel using three identical bolts $A, B$ and $C$, carries a load of $6$ kN as shown in the figure. Considering the effect of direct load and moment, the magnitude of resultant shear force (in kN) on bolt $C$ is $13$ $15$ $17$ $30$
asked Feb 27, 2017 in Applied Mechanics and Design Arjun 24.6k points
...