GATE2016-1-49

Arjun asked Feb 24, 2017 • recategorized Mar 5, 2021 by Lakshman Bhaiya

See all

Please log in or register to answer this question.

Related questions

0 answers

0 votes

Arjun asked Feb 24, 2017

GATE2016-1-45
For water at $25^\circ C$, $dp_s/dT_s = 0.189 \: kPa/K$ ($p_s$ is the saturation pressure in $kPa$ and $T_s$ is the saturation temperature in $K$) and the specific volume of dry saturated vapour is $43.38 \: m^3/kg$. Assume that the ... vapour. Using the Clausius-Clapeyron equation, an estimate of the enthalpy of evaporation of water at $25^\circ C$ (in $kJ / kg$) is __________

For water at $25^\circ C$, $dp_s/dT_s = 0.189 \: kPa/K$ ($p_s$ is the saturation pressure in $kPa$ and $T_s$ is the saturation temperature in $K$) and the specific volum...

Arjun

28.5k points

Arjun asked Feb 24, 2017

0 answers

0 votes

Arjun asked Feb 24, 2017

GATE2016-1-43
An infinitely long furnace of $0.5\:m\times 0. 4 \:m$ cross-section is shown in the figure below. Consider all surfaces of the furnace to be black. The top and bottom walls are maintained at temperature $T_1=T_3=927^\circ C$ ... loss or gain on side $1$ is_________ $W/m$. Stefan-Boltzmann constant = $5.67 \times 10^{-8}$ $W/m^2-K^4$

An infinitely long furnace of $0.5\:m\times 0. 4 \:m$ cross-section is shown in the figure below. Consider all surfaces of the furnace to be black. The top and bottom wal...

Arjun

28.5k points

Arjun asked Feb 24, 2017

0 answers

0 votes

Arjun asked Feb 24, 2017

GATE2016-1-42
A steel ball of $10\:mm$ diameter at $1000\:K$ is required to be cooled to $350\:K$ by immersing it in a water environment at $300\:K$. The convective heat transfer coefficient is $1000\:W/m^2-K$. Thermal conductivity of steel is $40\:W/m-K$. The time constant for the cooling process $\tau$ is $16\:s$. The time required (in $s$) to reach the final temperature is __________

A steel ball of $10\:mm$ diameter at $1000\:K$ is required to be cooled to $350\:K$ by immersing it in a water environment at $300\:K$. The convective heat transfer coeff...

Arjun

28.5k points

Arjun asked Feb 24, 2017

0 answers

0 votes

Arjun asked Feb 24, 2017

GATE2016-1-41
A steady laminar boundary layer is formed over a flat plate as shown in the figure. The free stream velocity of the fluid is $U_o$. The velocity profile at the inlet $a-b$ is uniform, while that at a downstream location $c-d$ ... rate, $\dot{m}_{bd}$ leaving through the horizontal section $b-d$ to that entering through the vertical section $a-b$ is ___________

A steady laminar boundary layer is formed over a flat plate as shown in the figure. The free stream velocity of the fluid is $U_o$. The velocity profile at the inlet $a-b...

Arjun

28.5k points

Arjun asked Feb 24, 2017

1 answers

0 votes

Arjun asked Feb 24, 2017

GATE2016-3-52
Two optically flat plates of glass are kept at a small angle $\theta$ as shown in the figure. Monochromatic light is incident vertically. If the wavelength of light used to get a fringe spacing of $1$ $mm$ is $450$ $nm$, the wavelength of light (in $nm$) to get a fringe spacing of $1.5$ $mm$ is _________

Two optically flat plates of glass are kept at a small angle $\theta$ as shown in the figure. Monochromatic light is incident vertically.If the wavelength of light used t...

Arjun

28.5k points

Arjun asked Feb 24, 2017

0 reply

Please log in or register to answer this question.

0 Answers

Related questions

0