# GATE2016-1-32

A horizontal bar with a constant cross-section is subjected to loading as shown in the figure. The Young’s moduli for the sections $AB$ and $BC$ are $3E$ and $E$, respectively.

For the deflection at $C$ to be zero, the ratio $\displaystyle{\frac{P}{F}}$ is ____________

recategorized

## Related questions

A hypothetical engineering stress-strain curve shown in the figure has three straight lines $PQ, QR, RS$ with coordinates P$(0,0)$, Q$(0.2,100)$, R$(0.6,140)$ and S$(0.8,130)$. $'Q'$ is the yield point, $'R'$ is the UTS point and $'S'$ the fracture point. The toughness of the material (in $MJ/m^3$) is __________
The principal stresses at a point inside a solid object are $\sigma _1$ = $100$ $MPa$, $\sigma _2$ = $100$ $MPa$ and $\sigma _3$ = $0$ $MPa$. The yield strength of the material is $200$ $MPa$. The factor of safety calculated using Tresca (maximum shear stress) theory is $n_T$ ... . Which one of the following relations is TRUE? $n_T=(\sqrt{3}/2)n_V$ $n_T=(\sqrt{3})n_V$ $n_T=n_V$ $n_V=(\sqrt{3})n_T$
A $300$ $mm$ thick slab is being cold rolled using roll of $600$ $mm$ diameter. If the coefficient of friction is $0.08$, the maximum possible reduction (in $mm$) is __________
A simply-supported beam of length $3L$ is subjected to the loading shown in the figure. It is given that $P=1\: N$, $L=1\:m$ and Young's modulus $E=200\:GPa$. The cross-section is a square with dimension $10\:mm\times10\:mm$. The bending stress ... beam at a distance of $1.5L$ from the left end is _____________ (Indicate compressive stress by a negative sign and tensile stress by a positive sign.)
The figure shows cross-section of a beam subjected to bending. The area moment of inertia (in $mm^4$) of this cross-section about its base is ________