search
Log In
0 votes

A cantilever beam with flexural rigidity of $200$ $N.m^2$ is loaded as shown in the figure. The deflection (in $mm$) at the tip of the beam is _______

in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
Consider a stepped shaft subjected to a twisting moment applied at $B$ as shown in the figure. Assume shear modulus, $G$ = $77$ $GPa$. The angle of twist at $C$ (in degrees) is __________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Consider a steel (Young’s modulus $E$ = $200 \: GPa$) column hinged on both sides. Its height is $1.0 \: m$ and cross-section is $10 \: mm \times 20$ $mm$. The lowest Euler critical buckling load (in $N$) is __________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A cantilever bracket is bolted to a column using three M$12×1.75$ bolts P, Q and R. The value of maximum shear stress developed in the bolt P (in $MPa$) is ________
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
0 votes
0 answers
The barrier shown between two water tanks of unit width $(1\: m)$ into the plane of the screen in modeled as a cantilever. Taking the density of water as $1000\:kg/m^{3}$ , and the acceleration due to gravity as $10\:m/s^{2}$ , the maximum absolute bending moment developed in the cantilever is _________$kN\cdot m$ (round off to the nearest integer).
asked Feb 19, 2020 in Applied Mechanics and Design jothee 4.9k points
...