search
Log In
0 votes

It is desired to avoid interference in a pair of spur gears having a $20^{\circ}$ pressure angle. With increase in pinion to gear speed ratio, the minimum number of teeth on the pinion

  1. increases
  2. decreases
  3. first increases and then decreases
  4. remains unchanged
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
A shaft is subjected to pure torsional moment. The maximum shear stress developed in the shaft is $100$ $MPa$. The yield and ultimate strengths of the shaft material in tension are $300$ $MPa$ and $450$ $MPa$, respectively. The factor of safety using maximum distortion energy (von-Mises) theory is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Consider a cantilever beam, having negligible mass and uniform flexural rigidity, with length $0.01$ $m$. The frequency of vibration of the beam, with a $0.5$ $kg$ mass attached at the free tip, is $100$ $Hz$. The flexural rigidity (in $N$.$m^2$) of the beam is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A butt weld joint is developed on steel plates having yield and ultimate tensile strength of $500$ $MPa$ and $700$ $MPa$, respectively. The thickness of the plates is $8$ $mm$ and width is $20$ $mm$. Improper selection of welding parameters caused an undercut of $3$ $mm$ depth along the weld. The maximum transverse tensile load (in $kN$) carrying capacity of the developed weld joint is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
...