search
Log In
0 votes
A rotating steel shaft is supported at the ends. It is subjected to a point load at the center. The maximum bending stress developed is $100$ $MPa$. If the yield, ultimate and corrected endurance strength of the shaft material are $300$ $MPa$, $500$ $MPa$ and $200$ $MPa$, respectively, then the factor of safety for the shaft is _______
in Applied Mechanics and Design 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
An annular disc has a mass $m$, inner radius $R$ and outer radius $2R$. The disc rolls on a flat surface without slipping. If the velocity of the center of mass is $v$, the kinetic energy of the disc is $\dfrac{9}{16}mv^2 \\$ $\dfrac{11}{16}mv^2 \\$ $\dfrac{13}{16}mv^2 \\$ $\dfrac{15}{16}mv^2$
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
Two solid circular shafts of radii $R_1$ and $R_2$ are subjected to same torque. The maximum shear stresses developed in the two shafts are $\tau _1$ and $\tau _2$. If $R_1$/ $R_2$=$2$, then $\tau _2/\tau _1$ is _______
asked Feb 19, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
The diameter of a recessed ring was measured by using two spherical balls of diameter $d_2$ = $60$ $mm$ and $d_1$ = $40$ $mm$ as shown in the figure. The distance $H_2$ = $35.55$ $mm$ and $H_1$ = $20.55$ $mm$. The diameter ($D$, in $mm$) of the ring gauge is _______
asked Feb 19, 2017 in Mechanics of Materials Arjun 24.6k points
0 votes
0 answers
A shaft of length $90 \: mm$ has a tapered portion of length $55 \: mm$. The diameter of the taper is $80 \: mm$ at one end and $65 \: mm$ at the other. If the taper is made by tailstock set over method, the taper angle and the set over respectively are $15^\circ 32′$ and $12.16 \: mm$ $18^\circ 32′$ and $15.66 \: mm$ $11^\circ 22′$ and $10.26 \: mm$ $10^\circ 32′$ and $14.46 \: mm$
asked Feb 24, 2017 in Applied Mechanics and Design Arjun 24.6k points
0 votes
0 answers
A rope-brake dynamometer attached to the crank shaft of an $I.C$. engine measures a brake power of $10$ $kW$ when the speed of rotation of the shaft is $400$ $rad/s$. The shaft torque (in $N$-$m$) sensed by the dynamometer is ___________
asked Feb 24, 2017 in Mechanics of Materials Arjun 24.6k points
...