Register

GATE Mechanical 2021 Set 1 | Question: 19

• edited by
0 votes
0 votes

Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in the figure. This shear stress distribution represents

  1. direct shear stress in the coil wire cross-section
  2. torsional shear stress in the coil wire cross-section
  3. combined direct shear and torsional shear stress in the coil wire cross-section
  4. combined direct shear and torsional shear stress along with the effect of stress concentration at inside edge of the coil wire cross-section
• edited by

Please log in or register to answer this question.

← PreviousNext →
← Previous in categoryNext in category →
Answer:

Related questions

0 answers
0 votes
gatecse asked Feb 22, 2021
GATE Mechanical 2021 Set 1 | Question: 6
The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains corresponding to $\text{200 MPa}$, respectively, are $0.01$ and $0.01$ $0.02$ and $0.01$ $0.01$ and $0.02$ $0.02$ and $0.02$
The loading and unloading response of a metal is shown in the figure. The elastic and plastic strains corresponding to $\text{200 MPa}$, respectively, are$0.01$ and $0.01...
0 answers
0 votes
gatecse asked Feb 22, 2021
GATE Mechanical 2021 Set 1 | Question: 7
In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to the plane of the generatrix as shown in figure, the surface generated is plane cylindrical spherical a surface of revolution
In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to the plane of the generatrix as shown in figure, the surface g...
0 answers
0 votes
gatecse asked Feb 22, 2021
GATE Mechanical 2021 Set 1 | Question: 8
The correct sequence of machining operations to be performed to finish a large diameter through hole is drilling, boring, reaming boring, drilling, reaming drilling, reaming, boring boring, reaming, drilling
The correct sequence of machining operations to be performed to finish a large diameter through hole isdrilling, boring, reamingboring, drilling, reamingdrilling, reaming...
0 answers
0 votes
gatecse asked Feb 22, 2021
GATE Mechanical 2021 Set 1 | Question: 9
In modern $\text{CNC}$ machine tools, the backlash has been eliminated by preloaded ballscrews rack and pinion ratchet and pinion slider crank mechanism
In modern $\text{CNC}$ machine tools, the backlash has been eliminated bypreloaded ballscrewsrack and pinionratchet and pinionslider crank mechanism
0 answers
0 votes
gatecse asked Feb 22, 2021
GATE Mechanical 2021 Set 1 | Question: 10
Consider the surface roughness profile as shown in the figure The center line average roughness ($R_{a}$, in $\mu m$) of the measured length $\text{(L)}$ is $0$ $1$ $2$ $4$
Consider the surface roughness profile as shown in the figureThe center line average roughness ($R_{a}$, in $\mu m$) of the measured length $\text{(L)}$ is$0$$1$$2$$4$
Voting & Accepting an answer helps improve the community
Link Copied!