Register

GATE2020-ME-2: 42

• retagged by
0 votes
0 votes
A mould cavity of $1200 \: cm^3$ volume has to be filled through a sprue of $10$ cm length feeding a horizontal runner. Cross-sectional area at the base of the sprue is $2 \: cm^2$. Consider acceleration due to gravity as $9.81 \: m/s^2$. Neglecting frictional losses due to molten metal flow, the time taken to fill the mould cavity is ________ seconds (round off to $2$ decimal places)
• retagged by

Please log in or register to answer this question.

← PreviousNext →
← Previous in categoryNext in category →
Answer:

Related questions

0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 20
A beam of negligible mass is hinged at support $P$ and has a roller support $Q$ as shown in the figure. A point load of $1200 \: N$ is applied at point $R$. The magnitude of the reaction force at support $Q$ is _________ $N$.
A beam of negligible mass is hinged at support $P$ and has a roller support $Q$ as shown in the figure.A point load of $1200 \: N$ is applied at point $R$. The magnitude ...
0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 21
A machine member is subjected to fluctuating stress $\sigma = \sigma_0 \cos (8 \pi t)$. The endurance limit of the material is $350$ MPa. If the factor of safety used in the design is $3.5$ then the maximum allowable value of $\sigma_0$ is _______ MPa. (round off to $2$ decimal places)
A machine member is subjected to fluctuating stress $\sigma = \sigma_0 \cos (8 \pi t)$. The endurance limit of the material is $350$ MPa. If the factor of safety used in ...
0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 22
A bolt head has to be made at the end of a rod of diameter $d=12$ mm by localized forging (upsetting) operation. The length of the unsupported portion of the rod is $40$ mm. To avoid buckling of the rod, a closed forging operation has to be performed with a maximum die diameter of _______ mm.
A bolt head has to be made at the end of a rod of diameter $d=12$ mm by localized forging (upsetting) operation. The length of the unsupported portion of the rod is $40$ ...
0 answers
0 votes
go_editor asked Sep 18, 2020
GATE2020-ME-2: 23
Consider the following network of activities, with each activity named $\textbf{A – L}$, illustrated in the nodes of the network. The number of hours required for each activity is shown alongside the nodes. The slack on the activity $\textbf{L}$, is _______ hours.
Consider the following network of activities, with each activity named $\textbf{A – L}$, illustrated in the nodes of the network.The number of hours required for each a...
Voting & Accepting an answer helps improve the community
Link Copied!