search
Log In
0 votes

For laminar forced convection over a flat plate, if the free stream velocity increases by a factor of $2$, the average heat transfer coefficient

  1. remains same
  2. decreases by a factor of $\sqrt{2}$
  3. rises by a factor of $\sqrt{2}$
  4. rises by a factor of $\sqrt{4}$
in Heat Transfer 24.6k points
recategorized by

Please log in or register to answer this question.

Answer:

Related questions

0 votes
0 answers
In a concentric counter flow heat exchanger, water flows through the inner tube at $25^\circ C$ and leaves at $42^\circ C$. The engine oil enters at $100^\circ C$ and flows in the annular flow passage. The exit temperature of the engine oil is $50^\circ C$. ... The specific heat of water and oil are $4178 J/kg.K$ and $2130 J/kg.K$, respectively. The effectiveness of this heat exchanger is _______
asked Feb 19, 2017 in Heat Transfer Arjun 24.6k points
0 votes
0 answers
A material P of thickness $1$ $mm$ is sandwiched between two steel slabs, as shown in the figure below. A heat flux $10$ $kW/m^2$ is supplied to one of the steel slabs as shown. The boundary temperatures of the slabs are indicated in the figure. Assume ... one-dimensional steady state heat conduction for the configuration, the thermal conductivity ($k$, in $W/m.K$) of material $P$ is _______
asked Feb 19, 2017 in Heat Transfer Arjun 24.6k points
0 votes
0 answers
A hemispherical furnace of $1$ m radius has the inner surface (emissivity, $\varepsilon =1$) of its roof maintained at $800$ $K$, while its floor ($\varepsilon =5.0$) is kept at $600 K$. Stefan-Boltzmann constant is $5.668 \times 10^−8$ $W / m^2$.$K^4$. The net radiative heat transfer (in $kW$) from the roof to the floor is _______
asked Feb 19, 2017 in Heat Transfer Arjun 24.6k points
0 votes
0 answers
In a heat exchanger, it is observed that $ΔT_1$ = $ΔT_2$, where $ΔT_1$ is the temperature difference between the two single phase fluid streams at one end and $ΔT_2$ is the temperature difference at the other end. This heat exchanger is a condenser an evaporator a counter flow heat exchanger a parallel flow heat exchanger
asked Feb 19, 2017 in Heat Transfer Arjun 24.6k points
0 votes
0 answers
The thermal efficiency of an air-standard Brayton cycle in terms of pressure ratio $r_p$ and $\gamma (= c_p /c_v)$ is given by $1-\dfrac{1}{{r_p}^{\gamma -1}} \\$ $1-\dfrac{1}{{r_p}^{\gamma }} \\$ $1-\dfrac{1}{{r_p}^{1/\gamma }} \\$ $1-\dfrac{1}{{r_p}^{(\gamma -1)/\gamma }}$
asked Feb 19, 2017 in Heat Transfer Arjun 24.6k points
...