GO Mechanical
0 votes

GATE2019-2-52

The thickness of a sheet is reduced by rolling (without any change in width) using $600 \: mm$ diameter rolls. Neglect elastic deflection of the rolls and assume that the coefficient of friction at the roll-workpiece interface is $0.05$. The sheet enters the rotating rolls unaided. If the initial sheet thickness is $2 \: mm$, the minimum possible final thickness that can be produced by this process in a single pass is ______ $mm$ (round off to two decimal places).

asked in Others by (21.5k points) 4 29 56
edited by

Please log in or register to answer this question.

Welcome to GO Mechanical, where you can ask questions and receive answers from other members of the community.

1,183 questions
37 answers
21 comments
2,609 users