# GATE Mechanical 2014 Set 1 | Question: 54

If the Taylor’s tool life exponent $n$ is $0.2$, and the tool changing time is $1.5$ $min$, then the tool life (in $min$) for maximum production rate is _______

recategorized

## Related questions

An aluminium alloy (density $2600$ $kg$/$m^3$) casting is to be produced. A cylindrical hole of $100$ $mm$ diameter and $100$ $mm$ length is made in the casting using sand core (density $1600$ $kg$/$m^3$). The net buoyancy force (in newton) acting on the core is _______
During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the chip produced is $0.5$ $mm$. The feed given to the zero degree rake angle tool is $0.2$ $mm/rev$. The shear strain produced during the operation is _______
A metal rod of initial length $L_0$ is subjected to a drawing process. The length of the rod at any instant is given by the expression, $L(t)=L_0(1+t^2)$ , where $t$ is the time in minutes. The true strain rate (in $min^{−1}$) at the end of one minute is _______
An ideal reheat Rankine cycle operates between the pressure limits of $10 \: kPa$ and $8 \: MPa$, with reheat being done at $4 \: MPa$. The temperature of steam at the inlets of both turbines is $500^ \circ C$ and the enthalpy of steam is $3185 \: kJ/kg$ at the ... Disregarding the pump work, the cycle efficiency (in percentage) is _______
In an air-standard Otto cycle, air is supplied at $0.1$ $MPa$ and $308$ $K$. The ratio of the specific heats $(γ)$ and the specific gas constant $(R)$ of air are $1.4$ and $288.8$ $J/kg.K$, respectively. If the compression ratio is $8$ and the maximum temperature in the cycle is $2660$ $K$, the heat (in $kJ/kg$) supplied to the engine is _______